Note
This is general section, that applies to all Tessel Software Line programs that uses INI
file.
- CurvePar
Integer value; specifies curvature parameter for tracing lines.
- Pickbox
Decimal value; specifies the size of snap pickbox (in pixels).
- SegmentPar
Integer value; specifies minimal segment length (in raster pixels) for tracing lines.
- SnapActive
Binary value; specifies whether snap to raster is active.
- SnapMode
Specifies snap mode value. Use the
Snap
tab on Configuration dialog to change it.- TraceWidth
Decimal value; specifies user-defined width to be used while tracing lines.
- UseTraceWidths
Binary value; specifies whether to use detected raster line widths while tracing lines.